Labels Milestones
BackTilted D Momentary Switch, single pole double throw, separate symbols | | | | | | C7, C12 | 3 | A1M | Potentiometer | | | L1 | 1 | 2_pin_Molex_connector | KK254 Molex header 2.54 mm spacing | | | | J9 | 1 | Synth_power_2x5 | 2x5 pin shrouded header 2.54 mm spacing D 3 rotary switches are actually 2p6t, which means only six different step counts are available until the replacement arrives Wiring SW15 (once/stop) and cascade out is easier done via skywiring; only one cross-board wire is needed, vs 3 if the measures have to be +1mm between legs - Trim 5mm from vertical for both panels, to make fitting inside a case easier. Or 10mm if it can fit; losing the bodge area. Outs: Clock Out - 1K to U2-14 Case Out - 1K to TP5 - Gate out (could normal to TP10, optional 2x Toggle Switches, 2pin: - all step switches (all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: - reset Pots, 3-pin: Glide attenuator (B10k) (join two left pins from below Clock rate goes down when resistance goes up, opposite to expectation. Schematic fixes: - C1 is too small; need more than 100k to get below 200bpm -- Clock POT.
- Generated footprint Coilcraft XAL60xx series, https://www.coilcraft.com/pdfs/xal60xx.pdf Coilcraft 0603USB.
- # For PCBs designed using KiCad.
- -3.439695e-15 -5.206609e-15 1.000000e+00 facet.
- 10VA, 1x Sec, Trafo Printtrafo CHK EI48 8VA.