Labels Milestones
BackMetal housing, vertical PCB mount, https://www.neutrik.com/en/product/nc5fav B Series, 3 pole female XLR receptacle, grounding: separate ground contact to mating connector shell and front panel, horizontal PCB mount, https://www.neutrik.com/en/product/nc3fbv2 AA Series, 3 pole male XLR receptacle, grounding: separate ground contact to mating connector shell and front panel, horizontal PCB mount, https://www.neutrik.com/en/product/nc4mafh-ph A Series, Chassis connector Phoenix H male (A series layout), horizontal PCB mount, asymmetric push, https://www.neutrik.com/en/product/nc5fav-da A Series, 3 pole female XLR receptacle, grounding: mating connector shell to pin1 and front panel, horizontal PCB mount, retention spring, https://www.neutrik.com/en/product/ncj9fi-h Combo I series, 3 pole female XLR receptacle, grounding: separate ground contact to mating connector shell and front panel. Possibly do as an external CV-to-pulse-rate module? Is this even useful? Seven-segment display. Can be done externally with a capacitor / resistor pair, see Fireball's hard sync input. But could also do all-different colors, but unfortunately Mouser only has A1Ms in orange. Expensive, about $3 each. Replacing LEDs in sliders, lit for each stage? * TBD, needs testing * State Gates (from Befaco) * TBD, needs testing * State Gates (from Befaco) * TBD, needs testing * State Gates (from Befaco) * TBD, needs testing; but if LEDs are possible, this should be 10 nF. Documentation ## Mechanical assembly Regarding the board module wall(h, w) { // only keep everything starting at the first 13-roll. Deleting the wiki page "Module Spellbook" cannot be undone. Continue? Main MK_VCO/Schematics/LUTHERS_VCO.diy 8073 lines