Labels Milestones
Back0 0.833884 0.55194 Latest commits for branch hard_sync Merge pull request 'new_footprints' (#5) from new_footprints into main ... Add notes about UX component wiring Add notes about wiring SW15 cross-board Add notes about UX component wiring 2x Sockets, all three pins need wires: glide in (sleeve and normal both GND 6x Sockets, 2pin: Gate out (could normal to TP10, optional) - Casc out 2x Toggle Switches, 2pin: - all step switches (all go to same bus run/stop 2x Pushbutton switches, all 2pin: - reset Pots, 3-pin: - Glide attenuator (B10k) (join two left pins from below Pots, 2-pin: Glide, manual (A100k) (two left pins, from below Clock rate goes down when resistance goes up, opposite to expectation. Glide fix Notes from MK's PCB livestream - avoid non-circular holes in footprints whenever possible.
- Phoenix PT-1,5-3-5.0-H pitch 5mm size 81.5x15mm^2.
- Series 15 https://www.tracopower.com/products/tmg.pdf ACDC-Converter TRACO TMLM 05 ACDC-Converter.
- 50Ohm, Edge Mount (http://suddendocs.samtec.com/prints/sma-j-p-x-st-em1-mkt.pdf.
- Normal -0.268373 -0.884719 0.381114 facet.