Labels Milestones
BackSwitches with 4 unused pins if supplying power, but not also under the front Don't put R8 so close to R26 -- D36/R47 too close Testing before powering up: Clock In - ~27K to U3-8? No, transistors maybe activate? Outs: Clock Out - 1K to U2-14 - Casc out 2x Toggle Switches, 2pin: all step switches (all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: - step - reset Pots, 3-pin: - Glide attenuator (B10k) (join two left pins from below - Clock POT is too small; need more than the Dailywell SPDT. | R31 | 1 README.md | 1 | SW_3PDT_x3 | Switch, triple pole double throw, center OFF position K switch dp3t ON-ON-ON D Switch, dual pole double throw, illuminated paddle, http://www.nkkswitches.com/pdf/gwillum.pdf switch single-pole double-throw ON-OFF-ON D Single Pole Single Throw (SPST) switch, small symbol D 5x DIP Switch, Single Pole Single Throw (SPST) switch, small symbol D Push button switch OFF-(ON CMOS General Purpose Timer, 555 compatible, PDIP-8 Quad operational amplifier, DIP-14"/>
New Pull Request