Labels Milestones
Back-12V and ground needed, probably up to it. MSD: L* L* -> only second half of normal; muffle optional? A series of boards, e.g. Https://learn.adafruit.com/adafruit-feather-m0-radio-with-rfm69-packet-radio Adafruit Feather 32u4 RFM Footprint for Mini-Circuits case GP1212 (https://ww2.minicircuits.com/case_style/GP731.pdf) following land pattern PL-079, including GND vias (https://ww2.minicircuits.com/pcb/98-pl230.pdf Footprint for Mini-Circuits case GP731 (https://ww2.minicircuits.com/case_style/GP731.pdf) following land pattern PL-230, including GND vias (https://ww2.minicircuits.com/pcb/98-pl230.pdf Footprint for SSR made by offering access to copy the files and the top (mm h_margin = hole_dist_side + thickness; width_mm = 70.8; // 14HP×5.08mm = 71.12; ES for 14HP is 70.8 c_tune = [second_col, fifth_row, 0]; //left_rib_x = thickness + 6 + tolerance; rail_depth = 27.4 + tolerance; // left_panel_width = 16.5+16.5+10.5; //two knob, one jack, plus space between them //left_panel_spacing = left_panel_width / 3 + tolerance*8; right_panel_width = width_mm - 10 LEDs - 3 5mm LEDs From b554ec213880d51d7ec2c0be275fddf38778f87d Mon Sep 17 00:00:00 2001 Subject: [PATCH] Checkpoint after fixes but before shrinking boards Checkpoint after fixes but before shrinking boards renamed repository from precadsrprecadsr to synth_mages/precadsr 2a5bb74bbd Stuff all teh scad files in aac0a4a5b4 Notes from debugging Do not connect the Normal pin for op amp in schmidt inverter mode, maybe both 7808 and hex inverter trigger are unnecessary? Alternative: Midi -> CV We could generate CV some other way for now, such as: * https://www.mouser.com/ProductDetail/Bourns/PTL30-15O0-105A2?qs=fV9UsjselOEqdQiKFAm%2Fog%3D%3D (A1M, orange LED, 30mm travel, 15mm shaft * https://www.mouser.com/ProductDetail/Bourns/PTL30-15R0-103B1?qs=X8nz4ozed5glbMOCRmYKzw%3D%3D (B10K, red LED, 30mm travel, 15mm shaft https://www.mouser.com/ProductDetail/Bourns/PTL30-15R0-103B1?qs=X8nz4ozed5glbMOCRmYKzw%3D%3D (B10K, red LED, 30mm travel, 15mm shaft * TBD, needs testing * State Gates (from Befaco) TBD, needs testing; but if LEDs are possible, this should be the same form factor, with maybe a little bit of margin $fn=FN; title_font = 10; // Center two holes two_holes_type = "opposite"; // [center, opposite, mirror] // Hole for setscrew // Make sure bottom ends at z=0 KnobMajorRadius+RingWidth) * 3, 20], center=true); } 3D Printing/Pot_Knobs/10mm_potentiometer_tool.stl Executable file Unescape move bugs to md file to be.
New Pull Request