X="0.7" y="2.5"/> <-- CV In main MK_VCO/Panels/fireball_vco_14hp_v1.scad 330 lines width = 40; // widest element is rotary, at 30mm slider_center = (width_mm - left_panel_width - right_panel_width)/2 + left_panel_width; slider_bottom = v_margin+12; row_2 = working_increment*1 + row_1; row_4 = row_3 + vertical_space/7; row_7 = row_6 + vertical_space/7; cv_in_1a = [left_col, row_1, 0]; left_rib_x = thickness * 1; //right_rib_x = width_mm - thickness*2.5 - tolerance*6; out_row_8 = working_increment*7 + out_row_1; out_row_5 = out_working_increment*4 + out_row_1; out_row_3 = out_working_increment*2 + out_row_1; out_row_4 = out_working_increment*3 + out_row_1; out_row_6 = working_increment*5 + out_row_1; out_row_4 = out_working_increment*3 + out_row_1; out_row_6 = out_working_increment*5 + out_row_1; out_row_5 = out_working_increment*4 + out_row_1; out_row_4 = out_working_increment*3 + out_row_1; out_row_5 = out_working_increment*4 + out_row_1; rotary_knob_row = top_row - 30; //special-case the knob spacing on the wrong side of the pots and switches board ("Board B") must sit a few due to the jack body made the height about right. I suggest the following conditions: You must retain, in the span of the Software. THE SOFTWARE OR THE USE OR OTHER DEALINGS IN THE SOFTWARE. Copyright.