3
1
Back

= [width_mm-h_margin, row_1, 0]; square_out = [third_col, fifth_row, 0]; pwm_duty = [input_column, bottom_row, 0]; c_tune = [width_mm/2 + h_margin, top_row, 0]; left_rib_x = thickness * 1; //right_rib_x = width_mm - thickness; left_panel_width = 12.5*3 + tolerance*4; // column from edge plus hole radius h_wall(h=4, l=slider_spacing * 10 + center_adjust; right_col = width_mm.

New Pull Request