Labels Milestones
Back's notes on updating the fireball for rev 2 Battery clip for batteries with a precision give to the front Don't put R8 so close to R26 -- D36/R47 too close - Trim 5mm from vertical for both panels, to make fitting inside a case easier. Or 10mm if it can fit; losing the bodge area. Outs: Clock Out - 1K to U2-14 - Casc out 2x Toggle Switches, 3pin: 11 Toggle Switches, 2pin: - all step switches (all go to same bus run/stop 2x Pushbutton switches, all 2pin: reset Pots, 3-pin: Glide attenuator (B10k) (join two left pins from below Clock rate goes down when resistance goes up, opposite to expectation. Schematic fixes: - C1 is too small for film; is film needed? Notes: Could make the clock 01bb4964a6 Add CV (and knob) controlled glide to schematic main arrasta/samba_reggae.txt 82 lines REP: repique MSD: mid surdo BSD: back surdo (L for low, H for high R/L: Accented Note (right/left.
- Normal 0.421912 -0.362633 0.830956 facet normal -8.391899e-02.
- Murata 1200RS Inductor, Radial series, Radial, pin.