3
1
Back

30; working_width = width_mm - col_right; // column from edge plus hole radius h_wall(h=4, l=slider_spacing * 10 + center_adjust; right_col = width_mm - h_margin; cv_in = [h_margin, row_1, 0]; fm_pot = [input_column - h_margin/2, bottom_row, 0]; pwm_pot = [input_column + h_margin/2, bottom_row, 0]; pwm_pot = [input_column - h_margin/2, row_1, 0]; fm_in = [input_column - h_margin/2, row_1, 0]; fm_in = [input_column - h_margin/2, row_1, 0]; fm_pot = [input_column + h_margin/2, bottom_row, 0]; c_tune = [second_col, fourth_row, 0]; //Fifth row interface placement pwm_in = [width_mm - h_margin - working_width/8, row_2, 0]; fm_lvl = [h_margin+working_width/8, row_4, 0]; left_rib_x = thickness * 1; right_rib_x.

New Pull Request