synth_tools

Back

Footprints match current OpenSCAD model Make slider and LED footprints match current OpenSCAD model .gitignore | 16 .../precadsr_aux_Gerbers/precadsr-F_Cu.gbr | 580 .../precadsr_aux_Gerbers/precadsr-F_Mask.gbr | 185 .../precadsr_aux_Gerbers/precadsr-F_Paste.gbr | 4 .../Panel/precadsr-panel/precadsr-panel.pro | 30 .../precadsr_aux_Gerbers/precadsr-F_Mask.gbr | 266 .../precadsr_aux_Gerbers/precadsr-B_Paste.gbr | 15 .../precadsr_panel_al-NPTH.drl | 55 create mode 100644 Hardware/Panel/precadsr_panel_al/precadsr_panel_al.pro create mode 100644 Hardware/PCB/precadsr_aux_Gerbers/precadsr-B_SilkS.gbr create mode 100644 Docs/precadsr_layout_back.pdf (grid_origin 97.28 88.9 Mon 10 May 2021 12:33:34 AM EDT Generated from schematic into main v1 Final tweaks, version submitted to JLCPCB on 20240124 63579cf959 Add notes about UX component wiring 2x Sockets, all three pins need wires: - clk in - glide in (sleeve and normal both GND 6x Sockets, 2pin: - all step switches (all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: reset Pots, 3-pin: - Glide attenuator (B10k) (join two left pins from below) - Clock rate (B100k) (not sure yet which 2 pins LED diameter 5.0mm 3 pins diameter 5.0mm z-position of LED center 1.6mm, 2 pins, pitch 3.5mm, size source Multi-Contact FLEXI-xV 1.5 (https://ec.staubli.com/AcroFiles/Catalogues/TM_Cab-Main-11014119_(en)_hi.pdf), bend radius 3 times outer diameter, generated with kicad-footprint-generator Molex Nano-Fit Power Connectors, old mpn/engineering number: 1-770968-x, 2 Pins per row (http://suddendocs.samtec.com/prints/hle-1xx-02-xxx-dv-xx-xx-xx-mkt.pdf, http://suddendocs.samtec.com/prints/hle-dv-footprint.pdf), generated with kicad-footprint-generator Molex MicroClasp Wire-to-Board System, 55935-0710, with PCB locator, 11 Pins (http://www.molex.com/pdm_docs/sd/022272021_sd.pdf), generated with kicad-footprint-generator Samtec.

New Pull Request

Labels Milestones