Labels Milestones
Back24 + 6.75; hole_left = slider_center - 13; hole_bottom = hole_top - 90; DivotRadius = KnobMinorRadius*.4; // Primary knob cylinder for (i=[0 : Knurls-1] rotate([0, 0, 180] // Left side: meta-step controls // run/stop (sw14 h_wall(h=4, l=slider_spacing*10-1, th=1); v_wall(h=4, l=height-rail_clearance*2-thickness, th=thickness*1.25); v_wall(h=4, l=height-rail_clearance*2, th=right_rib_thickness); // top stuff // How much horizontal space needed for left-hand and right-hand sub-panels right_panel_width = width_mm - hole_dist_side, hole_dist_top); cylinder(r=hole_r, h=thickness*2); echo("Putting a hole with radius: ", hole_r , " at ", hole_dist_side, hole_dist_top); cylinder(r=hole_r, h=thickness*2); echo("Putting a hole with radius: ", hole_r , " at ", width_mm - thickness*2; // How much horizontal space needed for left-hand and right-hand sub-panels left_panel_width = 40; // widest element is rotary, at 30mm slider_center = (width_mm - left_panel_width - right_panel_width)/2 + left_panel_width; slider_bottom = v_margin+12; Initial stab at a 10-step panel layout ideas left_rib_x = hole_dist_side + thickness; right_rib_x = width_mm - 9.5/2 - right_rib_thickness - tolerance; // rib + half a jack col_right = width_mm - col_right; // column from edge plus hole radius Panels/10_step_seq_38hp_v3.1.step_nob_up.scad Normal file Unescape.
- 1mm soldermask opening (recommended.
- 0.0914209 0.8816 vertex -4.61842 -4.98874 7.03804 facet.
- -0.95107 0.308975 -3.97753e-05 facet normal 9.140813e-01 -1.311190e-03 4.055288e-01.