Labels Milestones
Back(j1/j13 // gate out // cv out (j7/j6 // pause cv in (j18/j19 // run/stop (sw14 h_wall(h=4, l=slider_spacing*10-1, th=1); v_wall(h=4, l=height-rail_clearance*2-thickness, th=2); h_wall(h=4, l=slider_spacing*10+left_panel_width/2-right_rib_thickness, th=1.5); main MK_SEQ/Schematics/Unseen Servant/Unseen Servant.kicad_pro | 85 cd18ed43dc Added hard sync to schematic, laid out PCB with on-board components Moritz Klein (https://www.ericasynths.lv/shop/diy-kits-1/edu-diy-vca/ Two voltage-controlled amplifiers Two CV inputs for each, one primary and one with an attenuator, intended for use as tremolo - Manual offset knob 63579cf959 Add notes about UX component wiring 2x Sockets, all three pins need wires: - glide in (sleeve and normal both GND - Gate out, with probably +12v gates. Variable step count, 1-10 steps possible (with 2-3 extra switch positions to re-use for frequently-swapped positions). External reset via momentary push.
- Dual Switch 1110, Single Pot, Horizontal, Alps RK097.
- Pin (https://www.nxp.com/docs/en/data-sheet/PCF8523.pdf), generated with kicad-footprint-generator.
- For branch bugfix/v1.1 Add position for resistor between.