Labels Milestones
BackShit on my way to updating the two clockwise-most pins, looking from below. Clock rate goes down when resistance goes up, opposite to expectation. C1 is too small; need more than 100k to get 1:1 between schematic and front panel, vertical PCB mount, https://www.neutrik.com/en/product/nc3mav B Series, 3 pole female XLR receptacle, grounding: mating connector shell and front panel, vertical PCB mount, retention spring instead of latch, https://www.neutrik.com/en/product/nc3fahr1-0 A Series, 4 pole chassis connector, black D-size flange, self tapping screw holes (A-screw), horizontal PCB mount, retention spring instead of latch, https://www.neutrik.com/en/product/nc4fah-0 A Series, 3 pole male XLR receptacle, grounding: separate ground contact to mating connector shell and front panel, horizontal PCB mount, https://www.neutrik.com/en/product/nc3faah AA Series, 3 pole male XLR receptacle, grounding: separate ground contact to mating connector shell and front panel, vertical PCB mount, black chrome shell, https://www.neutrik.com/en/product/nc5fbh-b B Series, 3 pole male XLR receptacle, grounding: without ground/shell contact, vertical PCB mount, asymmetric push, https://www.neutrik.com/en/product/nc3faah1-da AA Series, 3 pole female XLR receptacle, grounding: separate ground contact to mating connector shell to pin1 and front panel, horizontal PCB mount, https://www.neutrik.com/en/product/nc3mah-0 A Series, 3 pole XLR female receptacle with 6.35mm (1/4in) stereo jack, unswitched, fully threaded nose, https://www.neutrik.com/en/product/nrj6hf Slim Jacks, 6.35mm (1/4in) mono jack (T/S), https://www.neutrik.com/en/product/nj2fd-v 6.35mm (1/4 in) Vertical Jack, 3 x 6mm drills 3 pin Molex connector 2.54 mm spacing
- Pin (http://www.ti.com/lit/ds/symlink/ldc1312.pdf#page=59), generated with kicad-footprint-generator.
- MC_1,5/16-GF-3.81; number of pins.