synth_tools

Back

173.184949 130.305 (end 187.6 112.5 (end 156.1 112.61 (end 161.6 76.4025 (end 161.6 72.75 (end 161.6 76.4025 (end 161.6 112.1 (end 162.78 113.28 (end 167.5 95.706712 (end 159.1 143.37 (end 151.32497 127.31492 (end 153.82497 118.046038 (end 163.459507 102.20756 (end 156.5 114.75 (end 155.46 113.25 (end 152.5975 112.013846 (end 156.5 132.238478 (end 163.459507 101.010493 (end 184.77 116.75 (end 168.85 107 (end 156 74.5 (end 162.35 77.1525 (end 155.1 107.67 (end 166.35 111.25 (end 183.66 112.0925 (end 181.3 115.5 (end 172.66 121.975 (end 154 115.75 (end 152.5 119.29 (end 151.4025 113.1525 (end 154 117.79 (end 165.75 123.4475 (end 176.5025 128.75 (end 166.4475 128.75 (end 166.4475 128.75 (end 166.4475 128.75 (end 165.75 119.5 (end 171.75 125 (end 164.22 117.97 (hatch edge 0.5 "name": "Grouped By Value", (offset 0.762) hide (end 1.016 2.54 (end -1.016 -2.54 (offset 0) hide (length 0) hide (length 0) hide (length 0) hide From 713014315986726ad96f361cfbc8e67551a6a879 Mon Sep 17 00:00:00 2001 Subject: [PATCH] Add CV in implement a DC offset via non-inverting op-amp. A CV in controls the clock feature/seq_chaining Checkpoint before trying to fit two mounting posts into hole_top = out_row_1 + 12 + 60 + 24 + 6.75; hole_left = slider_center - 13; hole_bottom = hole_top - 89.75; // these are for steps only row_1 = v_margin+12; // draw a horizontal wall (across the panel // h = shafthole_height, $fn = shafthole_faces); // Adapt to a D-shaped shafthole if desired. If(shafthole_cutoff_arc_height != 0) { 2 * LEDs in many places might be fine, might introduce intermittents - Don't put R8 so close to R26 -- D36/R47 too close Testing before powering up: Clock In Normal - 1k to U2-8 (AND NOT short to U2-10 - Clock rate (B100k) (not sure yet which 2 pins LED diameter.

New Pull Request

Labels Milestones