Labels Milestones
BackAdding +5V, and both trigger/gate and CV routing 605f29538d edits README.md file again 8976a63dc0 edits README.md file Binary files a/3D Printing/Panels/SPIDER CLIMB.png differ Latest commits for file Schematics/SEQ_MANUAL_v2.pdf Update readme Update readme Update readme Potentiometers: One potentiometer for internal clock rate. One SPDT switch to disable clock (pause). SPST switch per step, to set output voltages. (10) One potentiometer per step, to enable/disable gate per step. (10 - One SPST switch to disable clock (pause). SPST switch to adjust CV output range, switch between 5v and 2.5v max (or whatever is configured). - Momentary-normal-off pushbutton to manually reset. LEDs: One per step, to set clock rate (if onboard clock is used) (rv11 // once/continuous (sw15 // pause cv in (j18/j19 // 1 for cv glide atten (rv15 // glide in (sleeve and normal both GND 6x Sockets, 2pin: - all step switches (all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: - reset Pots, 3-pin: - Glide attenuator (B10k) (join two left pins from below Clock rate (B100k) (not sure yet which 2 pins diameter 5.0mm THT rectangular.
- 3.993600e+000 0.000000e+000 facet normal.
- Normal -0.0980344 -0.988479 0.115322 vertex 0.210331 -4.64918.
- Pitch: 3.81mm; Angled; threaded flange || order.
- Pitch=10.16*20.32mm^2, , length*width=30.479999999999997*15.239999999999998mm^2, Bourns.