3
1
Back

| 213 .../ao_tht.pretty/analogoutput_12mm.kicad_mod | 210 Hardware/PCB/precadsr/fp-lib-table | 1 | 4.7 uF | Polarized capacitor | | | | ----- | --- | ---- | ---- | ---- | ---- | ---- | ----------- | ---- | ---- | ----------- | ---- | | | | | J7, J8, J9 | 1 | 10nF | Ceramic capacitor | | | | R9 | 1 | 2_pin_Molex_connector | 2 | 47k | Resistor | | | Tayda | A-111 | | | | R25, R27, R29 | 3 | A1M | Potentiometer | | | | | | | R3, R21, R27, R28 | 3 | 1k | Resistor | | | | J7 | 1 | 1 Hardware/lib/aoKicad | 1 | SW_3PDT_x3 | Switch, single pole double throw, right angle, https://omronfs.omron.com/en_US/ecb/products/pdf/en-b3f.pdf tactile switch https://www.ckswitches.com/media/1973/ksc7.pdf C&K Switches 1P1T SMD PTS125 Series 12mm Tact Switch Low-profile SMD Tactile Switch, https://www.e-switch.com/system/asset/product_line/data_sheet/165/TL3342.pdf SWITCH SMD KSA SW 4-bit rotary coded switch, gull wing, https://www.nidec-copal-electronics.com/e/catalog/switch/sh-7000.pdf 4-bit rotary coded switch, gull wing, https://www.nidec-copal-electronics.com/e/catalog/switch/sh-7000.pdf 4-bit rotary coded switch, through-hole, https://www.nidec-copal-electronics.com/e/catalog/switch/sh-7000.pdf SPST Off-On Pushbutton, 1A, 30V, CW Industries P/N GPTS203211B, http://switches-connectors-custom.cwind.com/Asset/GPTS203211BR2.pdf SPST button tactile switch SPST LED OFF-ON lamp D Single Pole Single Throw (SPST) switch, small symbol D 9x DIP Switch, Single Pole Single Throw (SPST) switch, small symbol D 7x DIP Switch, Single Pole Single Throw (SPST) switch with signal lamp, generic K switch normally-open pushbutton push-button LCD D MEC 5G single pole double throw, separate symbols K switch normally-open pushbutton push-button D Push button switch, generic, symbol, four pins D Push button switch OFF-(ON) | Dailywell | PAS6B2M1CESG2-5, PAS6B2M4CESG6-5, or PAS6B2M4CESG6-5 | Tayda | A-804 | | | | Tayda | A-1955 | | | J12 | 1 | B10k | Potentiometer | | | Tayda | A-826 | | Tayda | A-827 | | C10 | 1 A painless, self-hosted Git service Simply run the.

New Pull Request