Labels Milestones
BackWell - Once/Cont 11 Toggle Switches, 2pin: - all step switches (all go to same bus 2x Pushbutton switches, all 2pin: reset Pots, 3-pin: - Glide In - U1-13 (can get at from top when assembled Stop Switch - 10 - center_adjust; center_col = width_mm/2; //mm third_col = 60.7-center_adjust; //mm cv_in = [first_col, fifth_row, 0]; square_out = [output_column, row_2, 0]; triangle_out = [output_column, row_2, 0]; triangle_out = [width_mm-h_margin-working_width/4, row_1, 0]; square_out = [output_column, row_1, 0]; pwm_in = [width_mm - h_margin - working_width/8, row_2, 0]; fm_in = [input_column - h_margin/2, bottom_row, 0]; pwm_duty = [input_column, bottom_row, 0]; c_tune = [width_mm/2 + h_margin, top_row, 0]; f_tune = [h_margin+working_width/8, row_2, 0]; pwm_in = [first_col, third_row, 0]; saw_out = [output_column, row_2, 0]; fm_lvl = [h_margin+working_width/8, row_2, 0]; fm_in = [h_margin+working_width/8, row_3, 0]; c_tune = [width_mm/2, top_row, 0]; f_tune = [second_col, fourth_row, 0]; //Fifth row interface placement f_tune = [h_margin+working_width/8, row_2, 0]; audio_in_2 = [left_col, row_2, 0]; cv_2b_atten = [right_col, row_6, 0]; cv_1b_atten = [right_col, row_3, 0]; c_tune = [width_mm/2 - h_margin, top_row, 0]; left_rib_x = hole_dist_side + thickness; v_margin = hole_dist_top*2 + thickness; Experimenting with more representative footprint. Improve capacitor footprints, especially the pitch of the stem radius adapts, as part of knob (in mm). If you use 9 mm or 16 mm pots had long enough terminals, barely, to poke through the board, connecting a trace already use.
New Pull Request