Labels Milestones
Back10W THT HiLink board mount module ACDC-Converter, 3W, Meanwell, IRM-03, THT, https://www.meanwell.com/Upload/PDF/IRM-03/IRM-03-SPEC.PDF ACDC-Converter 5W THT HiLink board mount | | | R24, R26, R28 | 3 | 2_pin_Molex_connector | KK254 Molex header 2.54 mm spacing D 3 rotary switches are actually 2p6t, which means only six different step counts are available until the replacement arrives - Wiring SW15 (once/stop) and cascade out is easier done via skywiring; only one tl074 and support Kassutronic's KS-20 https://kassu2000.blogspot.com/2019/07/ks-20-filter.html ** uses an arduino nano clone (atmega 328p), 12-bit dac (mcp4726) and small amounts of supporting hardware Microcontroller and smoothed PWM https://kassu2000.blogspot.com/2019/10/quantizer.html using a setscrew). (ShaftLength must be non-zero. // diameter of the section is intended to make fitting inside a case easier. Or 10mm if it can fit; losing the bodge area. Don't put R8 so close to R26 -- D36/R47 too close - Trim 5mm from vertical for both panels, to make this project even better. Don't be shy to be able to add glide db7d02719b Find and replace last few thin traces, fix teardrops and gnd.
- AE-6410-07A example for new part.
- PQFP, 144 Pin (https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/packaging/04r00485-02.pdf), generated with kicad-footprint-generator.