Labels Milestones
BackSyntax for the flat side (in mm). (Knurled ridges are not included in height. The shaft length is also not counted. KnobHeight = 20; // [0:0%, 10:10%, 20:20%, 30:30%, 40:40%, 50:50%] // Width of module (HP) width = 14; // [1:1:84] square_out = [third_col, third_row, 0]; //Fourth row interface placement fm_in = [h_margin+working_width/8, row_3, 0]; cv_in_2b = [right_col, row_2, 0]; triangle_out = [output_column, row_2, 0]; triangle_out = [output_column, row_1, 0]; fm_in = [h_margin+working_width/8, row_4, 0]; left_rib_x = thickness * 1; h_wall(h=4, l=right_rib_x); // middle horizontal rib // middle horizontal rib // h_wall(h=4, l=right_rib_x); // bottom horizontal rib // h_wall(h=4, l=right_rib_x); // one more vertical to mount a circuit outside the full dev board (in some cases) Arduino + DAC https://www.youtube.com/watch?v=t3kUPjdiq0o for explainer https://drive.google.com/drive/folders/156nn9rClRLJplS4M46s56-Pibi86Z-Kp for schematics and .ino file uses an LM13700 OTA (operational transconductance amplifier) (~$1.50, uncommon, and DIP marked obsolete) and NE5532 (uncommon, 80¢ based on the front Don't put R8 so close to R26.