Labels Milestones

Back

2mm no annular Mounting Hole 3.2mm, M3, DIN965 mounting hole 5.3mm no annular Mounting Hole 8.4mm, M8 mounting hole 2.1mm no annular m6 din965 Mounting Hole 4.3mm, M4 mounting hole position tweaks Messing around with panel alignment before printing 9a2ab6dc7f initial notes for other changes requested

change footprints of transistors to save on panel wires Move LED resistors next to transistors to wide

Add note that C12 is optional; not needed if using real TL0x4, fix pots being backwards, tighten up schematic, fit letter instead of latch, https://www.neutrik.com/en/product/nc4fav-0 A Series, Chassis connector Phoenix H male (A series layout), horizontal PCB mount, asymmetric push, https://www.neutrik.com/en/product/nc3faah1-da AA Series, 3 pole XLR female receptacle with 6.35mm (1/4in) switching stereo jack, vertical PCB mount, retention spring, https://www.neutrik.com/en/product/ncj9fi-v Combo I series, 3 pole XLR female receptacle with 6.35mm (1/4in) switching stereo jack without switching contact, horizontal PCB mount, https://www.neutrik.com/en/product/nc3mbv-0 B Series, 3 pole female XLR receptacle, grounding: separate ground contact.

• FFC/FPC Connector, For LVDS, 2.33mm Height, Right Angle.
• Two pins | Dailywell | PAS7B3M1CESA6-5 | Tayda.
• [left_col, row_3, 0]; cv_in_2b .
• Place counts as distribution of.

New Pull Request

0 Open 0 Closed

Label

Show archived labels

Use alt + click/enter to exclude labels

All labels No label

Milestone

All milestones No milestones

Project

All projects No project

0 Open 0 Closed

Close

Label

Clear labels

Milestone

No milestone

Projects

Clear projects