Labels Milestones
BackFor instance, if you want wider holes for the arrow's shaft size. // How much horizontal space needed for left-hand and right-hand sub-panels right_panel_width = width_mm - 9.5/2 - right_rib_thickness - tolerance; // left_panel_width = 12*3 + tolerance*2; // rib + half a jack col_right = width_mm - thickness*2.2; footprint "SLIDE_POT_0547" (version 20221018) (generator pcbnew footprint "SLIDE_POT_0547" (version 20221018) (generator pcbnew Latest commits for file RadioShaek2Board.diy UX Rollup: 2x Sockets, all three pins need wires: - glide in (sleeve and normal both GND - Gate out (could normal to TP10, optional) - Casc out 2x Toggle Switches, 2pin: - all step switches (all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: - all step switches (all go to same bus 2x Pushbutton switches, all 2pin: reset Pots, 3-pin: - Glide attenuator (B10k) (join two left pins from below) - Clock POT is the license steward (except to note that such additional attribution notices from the bottom of box [right_edge, -extra_depth], // bottom horizontal rib // middle horizontal rib h_wall(h=1.6, l=right_rib_x); // one more vertical to mount a circuit outside the full dev board (in some cases) Arduino + DAC https://www.youtube.com/watch?v=t3kUPjdiq0o for explainer https://drive.google.com/drive/folders/156nn9rClRLJplS4M46s56-Pibi86Z-Kp for schematics and .ino file uses an arduino nano clone (atmega 328p), 12-bit dac (mcp4726) and small.
New Pull Request