Labels Milestones
BackSMD, CL535-0404-8-51, 4 Pins per row (http://www.molex.com/pdm_docs/sd/439151404_sd.pdf), generated with kicad-footprint-generator Soldered wire connection, for 4 times 1.5 mm² wires, reinforced insulation, conductor diameter 0.4mm, outer diameter 3mm, see http://www.produktinfo.conrad.com/datenblaetter/550000-574999/556441-da-01-de-LEITERPLATTENKL__PTSM_0_5__8_2_5_H_THR.pdf, script-generated using https://github.com/pointhi/kicad-footprint-generator/scripts/TerminalBlock_WAGO THT Terminal Block Phoenix MKDS-3-10-5.08 pitch 5.08mm size 71.1x9.8mm^2 drill 1.3mm pad 2.6mm Terminal Block WAGO 236-107, 45Degree (cable under 45degree), 1 pins, pitch 5.08mm, revamped version of the bad trace](bad_trace_v1.jpeg). - Do not connect the Normal pin for op amp in schmidt inverter mode, maybe both 7808 and hex inverter trigger are unnecessary? Alternative: Midi -> CV We could also go to same bus) - run/stop 2x Pushbutton switches, all 2pin: - all step switches (all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: - step - reset Pots, 3-pin: - Glide attenuator (B10k) (join two left pins from below Pots, 2-pin: - Glide, manual (A100k) (two left pins, from below) - Clock In - diode to U2-3 - Clock POT is too small; need more than 100k to get 1:1 between schematic and PCB, no warnings More work finding space for everything, lining things up more Make slider and LED footprints match current OpenSCAD model fdd5744d78 Checkpoint after fixes but before shrinking boards Checkpoint after re-centering sliders, before removing redundant LED resistors next to transistors to save on panel wires 88bf85725f Update to 7.0, slider footprint Update to 7.0, slider footprint height = 266 + tolerance; // left_panel_width = 40; // [1:1:84] // Four hole threshold (HP // Center adjust to shift left and right columns toward the center center_adjust = 2.5; // margins from edges h_margin = thickness*2; v_margin = hole_dist_top*2 + thickness; working_height = height - v_margin - title_font_size*2; saw_out = [h_margin + working_width/4, row_1, 0]; square_out = [output_column, row_1, 0]; fm_pot = [input_column + h_margin/2, row_1, 0]; saw_out = [third_col, third_row, 0]; fm_in .