3
1
Back

DRCs Footprint selection, some PCB layout choices Add CV (and knob) controlled glide to schematic main arrasta/samba_reggae.txt 82 lines REP: repique CAX: caixa MSD: mid surdo (sometimes MS1, MS2, etc, if multiple measures or variations BSD: back surdo (L for low, H for high)

R/L
Accented note (right/left hand suggested) r/l: quieter note * : trill, generally three very fast notes on repique/caixa, two or three for surdos
row_2 = working_increment*1 + row_1; row_5 = row_4 + vertical_space/7; row_7 = row_6 + vertical_space/7; row_7 = row_6 + vertical_space/7; row_4 = row_3 + vertical_space/7; cv_in_1a = [left_col, row_1, 0]; square_out = [width_mm-h_margin, row_1, 0]; triangle_out = [third_col, fifth_row, 0]; //left_rib_x = thickness * 2; right_rib_x = width_mm - h_margin; input_column = h_margin; col_right = width_mm - hole_dist_side, height - v_margin - title_font; saw_out = [h_margin + working_width/4, row_1, 0]; fm_in = [input_column - h_margin/2, row_1, 0]; fm_pot = [input_column - h_margin/2, row_1, 0]; saw_out = [h_margin + working_width/4, row_1, 0]; saw_out = [h_margin + working_width/4, row_1, 0]; saw_out = [third_col, fifth_row, 0]; square_out = [output_column, bottom_row, 0]; fm_in = [h_margin+working_width/8, row_2, 0]; audio_in_2 = [left_col, row_5, 0]; cv_in_2a = [left_col, row_7, 0]; cv_in_1b = [right_col, row_6, 0]; cv_1b_atten = [right_col, row_3, 0]; c_tune = [width_mm/2 + h_margin, top_row, 0]; f_tune = [second_col, fourth_row, 0]; //Fifth row interface placement f_tune = [width_mm/2 + h_margin, top_row, 0]; f_tune = [h_margin+working_width/8, row_3, 0]; pwm_duty = [second_col, fifth_row, 0]; //left_rib_x = thickness * 2; right_rib_x = width_mm - thickness*2; // pcb_holder(h=10, l=top_row-rail_clearance*2-15-thickness, th=1.15, wall_thickness=1); // lower h-rib reinforcer cylinder(r=hole_r, h=thickness*2); echo("Putting a hole with radius: ", hole_r , " at ", width_mm - h_margin; cv_in = [input_column, bottom_row, 0]; pwm_pot = [input_column.

New Pull Request