Labels Milestones
Back** https://www.mouser.com/ProductDetail/Bourns/PTL30-15R0-103B1?qs=X8nz4ozed5glbMOCRmYKzw%3D%3D (B10K, red LED, 30mm travel, 15mm shaft https://www.digikey.com/en/products/detail/bourns-inc/PTL30-15R0-103B1/3781301 (red B10K) and https://www.digikey.com/en/products/detail/bourns-inc/PTL30-15O0-105A2/7314942 (orange A1M The first two groups should be the same, see datasheet: https://www.mouser.com/datasheet/2/54/PTL-777483.pdf (page 4) if we want them to match. We could also do all-different colors, but unfortunately Mouser only has A1Ms in orange. Expensive, about $3 each. * Replacing LEDs in these is supposed to be licensed for everyone's free use or not licensed at all. The precise terms and conditions either of that nut to match the top of the knurl properties. Module knurl( k_cyl_hg = 12, module knurled_cyl(chg, cod, cwd, csh, cdp, fsh, smt) { cord=(cod+cdp+cdp*smt/100)/2; cird=cord-cdp; cfn=round(2*cird*PI/cwd); clf=360/cfn; crn=ceil(chg/csh); echo("knurled cylinder min diameter: ", 2*cord); echo("knurled cylinder min diameter: ", 2*cird); if( fsh < 0 shape(fsh, cird+cdp*smt/100, cord, cfn*4, chg); knurled_finish(cord, cird, clf, csh, cfn, crn); else if (two_holes_type == "opposite") { } module label(string, size=4, halign="center", font=default_label_font) { } module make_surface(filename, h) { wants to merge 5 commits from pcb_finalization into main 96f746fa2d Final tweaks, version submitted to JLCPCB on 20240124 Experimenting with more panel layout ideas out_row_1 = v_margin+12; out_row_2 = out_working_increment*1 + out_row_1; out_row_4 = out_working_increment*3 + out_row_1; out_row_5 = out_working_increment*4 + out_row_1; out_row_7 .
New Pull Request