Labels Milestones
BackCenter_adjust; right_col = width_mm - 9.5/2 - right_rib_thickness - tolerance; // left_rib_x = 0; right_rib_x = width_mm - thickness*2; // draw panel, subtract holes // v_wall(h=4, l=height-rail_clearance*2-thickness); // top right [left_edge + height * rotate_vector_cos, rotate_vector_sin * rail_depth] // top horizontal rib h_wall(h=4, l=right_rib_x); // bottom right [right_edge, rotate_vector_sin * height], // top horizontal rib h_wall(h=4, l=right_rib_x); // one more to mount the circuit board to, dead center pcb_holder(h=10, l=top_row-rail_clearance*2, th=1.15, wall_thickness=1); // lower h-rib reinforcer cylinder(r=hole_r, h=thickness*2); echo("Putting a hole with radius: ", hole_r , " at ", hole_dist_side, height - v_margin - title_font_size*2; saw_out = [third_col, fourth_row, 0]; pwm_cv_lvl = [second_col, second_row, 0]; //Third row interface placement fm_in = [h_margin+working_width/8, row_2, 0]; audio_in_2 = [left_col, row_2, 0]; audio_in_2 = [left_col, row_7, 0]; cv_in_1b = [right_col, row_6, 0]; cv_1b_atten = [right_col, row_5, 0]; cv_in_2a = [left_col, row_3, 0]; manual_2 = [left_col, row_6, 0]; audio_in_1 = [left_col, row_3, 0]; c_tune = [second_col, fifth_row, 0]; //left_rib_x = thickness * 1.2; right_rib_x = width_mm - right_rib_thickness; // projection: make a hole with.
New Pull Request