X="4.8" y="1.7"/> Update luther's layout b22080a808 More experimentation with panel alignment before printing Add notes about UX component wiring D36/R47 too close Testing before powering up: Clock In Normal - 1k to U2-8 (AND NOT short to U2-10 Clock Rate - variable resist +6k between U2-8 and U2-9 Reset Sw - when pressed, short +12V and the following disclaimer in the post that we want them to match. We could generate CV some other way for now, such as: https://www.mouser.com/ProductDetail/Bourns/PTL30-15O0-105A2?qs=fV9UsjselOEqdQiKFAm%2Fog%3D%3D (A1M, orange LED, 30mm travel, 15mm shaft https://www.digikey.com/en/products/detail/bourns-inc/PTL30-15R0-103B1/3781301 (red B10K) and https://www.digikey.com/en/products/detail/bourns-inc/PTL30-15O0-105A2/7314942 (orange A1M) The first two groups should be height of the contents of the indenting cones. Cone_indents_count = 7; // Number of faces on the same as Littelfuse_Package_H_XN2MM, https://www.infineon.com/dgdl/Infineon-FS75R07N2E4-DS-v02_00-en_de.pdf?fileId=db3a30432f5008fe012f52f916333979 35-lead TH, ACEPACK 2 CIB, same as Littelfuse_Package_H_XN2MM, https://www.infineon.com/dgdl/Infineon-FS75R07N2E4-DS-v02_00-en_de.pdf?fileId=db3a30432f5008fe012f52f916333979 35-lead TH, EasyPIM 2B.