Labels Milestones
BackArrives Wiring SW15 (once/stop) and cascade out is easier done via skywiring; only one cross-board wire is needed, vs 3 if the PCB is used. In loop position, loop\nis connected to shell ground, but not that small - C3 and C4 could use fewer caps that way PSU/psu.diy Executable file View File 3D Printing/Panels/AD&D 1e spell names rendered as raster using Filmoscope Quentin Potentiometers: One potentiometer per step, to indicate current step. (10) Sockets: CLOCK in RESET / CASCADE out - Gate out, with switch for two different ranges (e.g. 0-2.5v / 0-5v Gate out, with switch for two different ranges (e.g. 0-2.5v / 0-5v - Gate out (could normal to TP10, optional) - Casc out 2x Toggle Switches, 3pin: 11 Toggle Switches, 2pin: - all step switches (all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: - step - reset Pots, 3-pin: - Glide attenuator (B10k) (join two left pins from below Clock rate (B100k) (not sure yet which 2 pins.
- 2mm or 2.5mm center pin, https://www.kycon.com/Pub_Eng_Draw/KLDX-0202-AC%20&%20BC.pdf.
- 6 2x8 IDC power connectors.
- The indenting cones. ≥30.