Labels Milestones
BackPins need wires: - glide in (sleeve and normal both GND 6x Sockets, 2pin: - reset Pots, 3-pin: - Glide attenuator (B10k) (join two left pins from below) - Clock rate goes down when resistance goes up, opposite to expectation. Schematic fixes: Trim 5mm from vertical for both panels, to make fitting inside a case easier. Or 10mm if it faces away and so on. // body - hole // handle + rest of body // knurled handle (requires https://www.thingiverse.com/thing:32122 //knurled_cyl( clf_partHeight, clf_handle_diameter, 2, 2, 2, true, 10 ); // the main module. It calls the submodules. // smoothing = true; arrow_scale_shaft = 1.5; // How much horizontal space needed for left-hand and right-hand sub-panels left_panel_width = 40; // widest element is rotary, at 30mm right_panel_width = 12; // [1:1:84] left_rib_x = thickness * 2; right_rib_x = width_mm - col_right + tolerance*4; // column from edge plus hole radius //calculated x value of exact middle of slider panel (between steps 5 and 6); middle of panel after deducting left/right sub-panels slider_center = (width_mm - left_panel_width - right_panel_width)/2 + left_panel_width; slider_bottom = v_margin+8; Panels/10_step_seq_38hp_v1.scad Normal file View File 3D Printing/Panels/AD&D 1e spell names in Filmoscope Quentin/Panels/POLYMORPH.png differ Binary.
New Pull Request